Showing 0–10 of 75 results

Power Strip Clamp Mounts Securely on Your Desktop without DrillingThis clamp-on holder for power strips and surge protectors is easy to install without the hassle of drilling into walls or workbenches. Keep AC outlets and USB ports within easy reach of your desk, table or workspace by attaching the CLAMPUSBLK to any flat surface 0.4 to 2 inches thick. No tools are needed. Just slide the clamps onto the surface’s edge, tighten the adjustment knobs by hand, and snap your surge or power strip into the mounting clip.No More Crawling Under Desks to Plug Devices into Hard-to-Reach OutletsAdd AC and USB power where you most need it. The CLAMPUSBLK lets you install a power strip or surge protector within an arm’s reach of your chair. The heavy-duty plastic clamp accepts most strips 1.6 to 2.4 inches in width. Soft EVA foam pads on the clamp protect your desk from scuffs and scratches.Retrofit Existing Installations to Improve Access to Outlets Add AC outlets and USB ports somewhere new or change the mounting of an existing power or surge strip to improve access to power. A cable management clip in the rear keeps power cords neat and tidy.

Cable Ladder Ceiling Support Kit Secures Your Data Center’s Runway SystemThis lightweight SmartRack cable runway ceiling support kit creates a secure point of attachment from the ceiling of your server room or data center to a ladder section. It includes two brackets that connect to the ceiling and two brackets to support the cable runway. Threaded rods and appropriate fasteners are not included. The mounting surface must be able to support the combined equipment load safely. Be sure to use suitable mounting means when installing to cinder block, concrete, drywall or wooden studs. The innovative SRLCEILINGKIT is designed for use with SRCABLELADDER, SRCABLELADDER18, SRL90BEND12, SRL90BEND18 and other compatible 12-inch (305-millimeter) and 18-inch (457-millimeter) straight and 90-degree ladder sections.

Wall Support Kit 12in Cable Runway Straight and 90-Degree

Cable Runway E-Bend Creates a 90-Degree Gradual Sweep for Horizontal Cable Ladder RunsThe SmartRack SRL90BEND18 allows you to place a curved right angle in your horizontal cable runway application. It connects to your 18-inch cable runway above your rack enclosure or open frame rack to allow flexibility in your overhead cable routing. Install it either parallel or perpendicular to the rack for clean, organized cable routing across an aisle or within a row.Measures 18 in. Wide with a 33 in. Wide BendThis cable E-bend conforms to minimum-bend radius requirements (typically four times the cable diameter). It’s made from lightweight tubular steel measuring 1.5 x 0.375 inches (38 x 9.5 millimeters). It fits 18-inch (457-millimeter) cable runway widths, and meets Cat5e/6/6a requirements.Designed for Use with Rack Cabling ComponentsThe SRL90BEND18 ships fully assembled for connecting right out of the package. It’s compatible with 18-inch SRCABLELADDER18 and SRLBUTTSPLICE kit for toolless assembly. All accessories are sold separately.

Junction-Splice Kit for Tripp Lite 90-Degree Ladder Runway Connections - Hardware Included

Butt-Splice Kit for Straight & 90 Degree Ladder Runway Sections