Showing 510–520 of 643 results

The RAM-VP-SW1-47 consists of a 7" lower female Tele-Pole, 4" upper male Tele-Pole, double swing arm and 2.5" round base that contains the universal AMPs hole pattern. The lower female Tele-Pole will attach to all RAM vehicles bases that do not contain a welded female Tele-Pole. The height of the Tele-Poles, combinded, can easily be adjusted by turning the knob at the top of the post. Once the knob has been tightened, the Tele-Pole becomes a rigid support for connecting devices or cradles. The double swing arm allows you to twist and tilt the viewing angle of your connected electronic device, when mounted on your RAM Vehicle Mount. The rotating swivel arm gives you even more viewing positions for your mounted electronic device while holding everything firmly in place. The length of the double swing arm is 12".

The RAM-101U-B-235 consists of a short double socket arm, one round 2.5" diameter round base with the universal AMPS hole pattern and stainless steel double u-bolt base that will fit pipes from 1" to 1.25" in diameter. Designed into the mount is a 1.5" diameter patented rubber ball and socket system with adjustment points at both socket ends of the arm. Rubber ball and socket technology allows for almost infinite adjustment and perfect viewing angles.

The RAM antenna mount is designed to hold most VHF and similar antennas. The patented rubber ball and socket system securely mounts the antenna while allowing for almost infinite adjustment. Mount the antenna on a horizontal or vertical surface or anywhere in between. The ball base is made from a light weight marine grade aluminum with powder coat. The ball socket and male 1" -14 threaded post are made from high strength composites designed for prolonged outdoor use. The RAM antenna mount will work with any standard antenna that has a 1" -14 threaded interface.

The RAM-103-B-238U consists of the 1.5" C size diameter ball and socket system with one open socket end; RAM-201U-B socket arm is short length at 3.56" end to end with 2.5" socket-to-socket length. This mount is designed to be used with any of the C size RAM Mount bases or cradles with a 1.5" diameter rubber ball. The RAM-238U RAM Diamond Ball Base features industry standard AMPS 2-hole pattern and can be used as an adapter to attach a holder, or a mounting drill-down base.

The RAM-B-238-VEN1U consists of a 1" diameter rubber ball connected at right angles to a 1.25" x 2.5" inch diamond base. The base has two holes 1.912" from center to center, positioned at both ends of the diamond base. Included is hardware that will attach the adaptor base directly to the Venom camera factory cradle.

The RAM-B-108BU-HUM1 consists of a 1" diameter rubber ball connected at a right angle to a v-shaped base. The RAM-B-108BU-HUM1 accommodates rails from 1.0" to a maximum of 2.1" in diameter. To mount the RAM-B-108BU-HUM1 base, place the saddle shaped plate on the rail then wrap the metal clamp strap around the rail and plate. Tighten the screw knob on the metal strap with a screw driver until the strap has a firm hold on the rail. The RAM-B-108BU-HUM1 is an alternative mounting base for Beechcraft airplanes with a "throw over yoke".

The RAM-B-201-C-KRU, long double socket arm, has a socket at both ends that accommodate 1" ball bases. A single spring inside the arm opens the end sockets, allowing you to pivot the ball and socket connection. This socket technology allows for almost infinite adjustment and perfect viewing angles. The knob has a locking Acorn nut that prevents the mount from being removed from the socket. This Feature allows for a secure mount while giving the ability to adjust your device without the ability to remove the device.