Showing 100–110 of 643 results

The RAM-246-2461U consists of a double socket arm, 3.625" square plate and 4.75" square plate. The 3.625" square plate contains a 75mm X 75mm VESA hole pattern. The 4.75" square plate contains a 4x100mm holes and 4x75mm hole pattern. Designed into the mount is a 1.5" diameter patented rubber ball and socket system with adjustment points at both socket ends of the arm.

The Center Loader allows for the connection of two Extruded Aluminum Tough-Track systems in a straight line and provides a loading point to insert track bases. Hardware not included.

The RAP-BB-230-18-201U consists of a LONG extension pole with (2 qty) 1" diameter ball ends and double socket arm. - Extension poles are buoyant, will float if dropped in the water - All components are plastic or stainless steel making this camera system the perfect solution for many outdoor activities, including saltwater applications - Light weight, easily adjustable and packable. Easily break down your camera system to stow when not in use - Modular system allows for infinite configurations. Easily capture self-portrait images from water level, overhead shots and even underwater images of your latest catch - Easily rotate the mounted camera to operate on-board functions, check shot angles and other critical adjustments

The RAM-D-101-254U consists of a 3.68" diameter round base, STANDARD length double socket arm and 2.43" diameter round base. The 3.68" diameter round base has pre-drilled holes, including two holes at 180 degrees and three holes at 120 degrees. The 2.43" diameter round base contains the universal AMPs hole pattern. Designed into the mount is a 2.25" diameter patented rubber ball and socket system with adjustment points at both socket ends of the arm. Rubber ball and socket technology allows for almost infinite adjustment and perfect viewing angles.

The RAM-D-235U consists of a double u-bolt base with 2.25" diameter ball and two stainless steel u-bolts. The double u-bolt base will accommodate rails from 1" to 1.25" in diameter.

The RAM Track Ball is made up of a B size 1" rubber ball molded to a high strength composite base, a rubber friction washer and a stainless steel T-bolt for sliding into virtually any track system. Simply insert or slide the Track Ball into your track and twist the ball clockwise to tighten in place. Twist counterclockwise to loosen or adjust the ball. T-Bolt Dimensions: .48" x .95"

The RAM-B-347-G4 base consists of a 1" diameter rubber ball connected at right angles to a 2" x 1.7" square base. The base has four pre-drilled holes at each corner, making the universal 1.5 x 1.188 (hole spacing) AMPS hole pattern.

The single socket for a C size 1.5" ball that has a socket for Octagon Button products. This configuration gives you the ability to interface with the variety of Octagon Button bases, couplers, and pipe mounts.