Showing 130–140 of 643 results

The RAP-B-379U-M10-JD1 consists of a 1" diameter rubber ball, connected to a M10-1.5 X 25MM male threaded post.

The RAM-224-3U consists of a triple suction cup base with 1.5" diameter ball. The RAM-224-3U is designed to have an extra strong hold on any smooth non-porous surface, but for best result, mount the RAM-224-3U on a glass or non-porous plastic surface.

The RAM-VP-SW1-12 consists of a 12" upper male Tele-Pole, double swing arm and 2.5" round base that contains the universal AMPs hole pattern. The Tele-Pole can be easily adjusted by turning the knob at the top of the post. Once the knob has been tightened, the Tele-Pole becomes a rigid support for connecting devices or cradles. The Tele-Pole will connect to any RAM vehicle base with a welded female Tele-Pole. The double swing arm with rotating plate, allows you to twist and tilt the viewing angle of your connected electronic device, when mounted on your RAM Vehicle Mount. The rotating swivel arm gives you even more viewing positions for your mounted electronic device while holding everything firmly in place. The length of the double swing arm is 12".

The RAM motorcycle handlebar base contains a 1.5" rubber ball designed to sit at right angles to the mounting rail. The "Rust-Proof" stainless steel u-bolt accommodates rails in diameter from 0.5" to 1" in diameter. Included are black cover caps to be placed over the exposed ends of the u-bolt and a composite adapter that can narrow the rail to a minimum width of 0.5".

The RAM-109V-4U consists of a 6" long curved swing arm with open socket and vertical surface mounting base. There are two (2) pivoting points on the mount: one at the swing arm and base and one at the center of the open single socket. Each pivoting point allows a complete 360 degree rotation. The open socket will accommodate all RAM 1.5" diameter ball component parts.

Here at RAM we are all about options. Even when approaching a simple design we make sure to present several options to our customers so we are sure to meet and exceed their expectations. Take a look at the new line of microphone clips for the RAM Tough-Box Console System. The RAM microphone clip features a no-fail safety latch which holds the microphone securely while not in use. This latch can also be easily removed to achieve a quick release feature. Offering the ability to quickly adjust or remove the microphone clip, this solution utilizes three "rare two magnets" to securely attach the clip to the console box. RAM products are backed by the renowned NPI Lifetime Warranty.

The RAM-220U is a half rail clamp base with 1.5" rubber ball that will connect to rails from 1" to 1.25" in diameter.

The RAM-D-243U consists of a 2.25" diameter rubber ball, connected at right angles to a square 2.81" x 5" plate.