Showing 250–260 of 643 results

This RAM No-Drill mounting system installs quickly and easily into the 2019 Chevrolet All-New Silverado and GMC Next Generation Sierra using the existing hardware of the passenger side seat rails. This configuration provides a telescoping feature that ranges from 12” to 18”. Dual swing arms provide articulation and 12” of reach for passenger and driver access to the mounted device. The round ball base attached to the end of the swing arm supports a variety of tablet and laptop holders, while RAM rubber ball and socket technology provides additional adjustability as well as shock and vibration isolation.

Convert any RAM post/spline base into a ball base on your boat or kayak with this 1" ball with spline post. With this adapter you can use your existing rod holder base to support a wide variety of ball and socket components to hold your phone, camera or other handheld device. With the post and spline function you can easily remove or transfer your double ball mount when not in use.

The RAM-GDS-DOCKT-SAM16U includes the top docking cup and necessary hardware for converting your existing GDS Vechicle Dock to support the Samsung Galaxy Tab A 8.0 with IntelliSkin. Without having to purchase a brand new vehicle dock, this top cup allows you to modify your existing dock to work with your new IntelliSkin device. The modularity of the Tab-Tite, Tab-Lock, and GDS Vehicle Docks will always provide the highest quality and most cost-effective solutions for any tablet you own, including any future upgrade tablets. Learn more about other ways you can modify or upgrade your tablet holder

The coupler is to combine 2 RAP-B-200-1U and/or RAP-200-1U to form a double socket arm with the capability to rotate 360 in the center of the arm. This will also give the ability to have a B size 1" ball socket on one side and a C size 1.5" ball socket on the other. This is intended for light duty uses.

The RAP-319U is a composite adapter that is designed to narrow the rail width of RAM u-bolts to a minimum of 0.5".

The RAM-B-108BU-HUM1 consists of a 1" diameter rubber ball connected at a right angle to a v-shaped base. The RAM-B-108BU-HUM1 accommodates rails from 1.0" to a maximum of 2.1" in diameter. To mount the RAM-B-108BU-HUM1 base, place the saddle shaped plate on the rail then wrap the metal clamp strap around the rail and plate. Tighten the screw knob on the metal strap with a screw driver until the strap has a firm hold on the rail. The RAM-B-108BU-HUM1 is an alternative mounting base for Beechcraft airplanes with a "throw over yoke".

The RAM-111BT universal base has a short post connected at right angles to a flat 6.25 x 2 inch rectangular base. The base has many different combinations of pre-drilled holes which will match up to many electronic devices and mounts, including Marine GPS, CB Radios, Ham Radios, Gimbal Brackets and more. The small post on the base is designed to connect to the RAM-109 series arms. Included on the end of the post is a tightening knob for use when installed on the compatible RAM-109 series arm.