Showing 270–280 of 643 results

The RAM-VP-SW1-47 consists of a 7" lower female Tele-Pole, 4" upper male Tele-Pole, double swing arm and 2.5" round base that contains the universal AMPs hole pattern. The lower female Tele-Pole will attach to all RAM vehicles bases that do not contain a welded female Tele-Pole. The height of the Tele-Poles, combinded, can easily be adjusted by turning the knob at the top of the post. Once the knob has been tightened, the Tele-Pole becomes a rigid support for connecting devices or cradles. The double swing arm allows you to twist and tilt the viewing angle of your connected electronic device, when mounted on your RAM Vehicle Mount. The rotating swivel arm gives you even more viewing positions for your mounted electronic device while holding everything firmly in place. The length of the double swing arm is 12".

The RAM-101U-B-235 consists of a short double socket arm, one round 2.5" diameter round base with the universal AMPS hole pattern and stainless steel double u-bolt base that will fit pipes from 1" to 1.25" in diameter. Designed into the mount is a 1.5" diameter patented rubber ball and socket system with adjustment points at both socket ends of the arm. Rubber ball and socket technology allows for almost infinite adjustment and perfect viewing angles.

The RAM-B-108BU-HUM1 consists of a 1" diameter rubber ball connected at a right angle to a v-shaped base. The RAM-B-108BU-HUM1 accommodates rails from 1.0" to a maximum of 2.1" in diameter. To mount the RAM-B-108BU-HUM1 base, place the saddle shaped plate on the rail then wrap the metal clamp strap around the rail and plate. Tighten the screw knob on the metal strap with a screw driver until the strap has a firm hold on the rail. The RAM-B-108BU-HUM1 is an alternative mounting base for Beechcraft airplanes with a "throw over yoke".

The RAM-D-101-ID1U consists of a 3.68" diameter round base, STANDARD length double socket arm and 4.75" square plate. The 3.68" diameter round base has pre-drilled holes, including two holes at 180 degrees and three holes at 120 degrees. The 4.75" square plate contains 4x100mm holes and 4x75mm holes in each corner. Designed into the mount is a 2.25" diameter patented rubber ball and socket system with adjustment points at both socket ends of the arm. Rubber ball and socket technology allows for almost infinite adjustment and perfect viewing angles. Weight Capacity: Up to 6 lbs. Plate Hole Patterns

The RAM-B-238-VEN1U consists of a 1" diameter rubber ball connected at right angles to a 1.25" x 2.5" inch diamond base. The base has two holes 1.912" from center to center, positioned at both ends of the diamond base. Included is hardware that will attach the adaptor base directly to the Venom camera factory cradle.

The RAM-B-201-C-KRU, long double socket arm, has a socket at both ends that accommodate 1" ball bases. A single spring inside the arm opens the end sockets, allowing you to pivot the ball and socket connection. This socket technology allows for almost infinite adjustment and perfect viewing angles. The knob has a locking Acorn nut that prevents the mount from being removed from the socket. This Feature allows for a secure mount while giving the ability to adjust your device without the ability to remove the device.