Showing 50–60 of 643 results

The RAM-D-271U-2, round pipe base, consists of a 2.25" rubber ball connected that will connect to a pipe tubing diameter from 2" to 2.5" in diameter.

The RAM-201U-BL, standard double socket arm with small size locking knob, has a socket at both ends that accommodates 1.5" ball bases. A single spring inside the arm opens the end sockets, allowing you to pivot the ball and socket connection. This socket technology allows for almost infinite adjustment and perfect viewing angles. The locking knob, includes a brass 1/4"-20 thread; this allowing you to disengage the screwing of the knob. Once you have set your mount in the location you need, you can lock it in place and feel safe that your mounted device will stay right where you left it.

With the RAM Tough-Track, flat surface mounting possibilities are nearly endless for ATVs, cars, combines, motorboats, tractors, trucks, and more. This track mount solution can be drilled to any flat surface and is designed for use with #10 screws for easy installation hardware not included. The Tough-Track works with a wide variety of RAM track bases to attach devices like action cameras, fishing rods, phones, and tablets. Dimensions: Overall length: 18.5" Overall width: 1.75" Track thickness: .35" Inside track length: 16"

Connect another device to your existing RAM Mount with the RAM-B-273U Ball Base Adapter. This ball is made up of a 1" ball connecting to a 1/4"-20 threaded stud with a length of 1.6". The threads on this ball replace the bolt in any B-size socket arm, and the ball connects to the middle of the socket arm on the opposite side of the tightening knob. If you are looking to mount more than one device but cannot locate multiple mounting points on your motorcycle or vehicle, this base is the ideal accessory for connecting both devices off of one mounting base.

The RAM-E-202U-IN1 consists of a 3.38" diameter rubber ball, connected at right angles to a 3.68" diameter round plate. The plate has pre-drilled holes in the base plate, including two holes at 180 degrees and three holes at 120 degrees.

The RAM Track Ball is made up of a B size 1" rubber ball molded to a high strength composite base, a rubber friction washer and a stainless steel T-bolt for sliding into virtually any track system. Simply insert or slide the Track Ball into your track and twist the ball clockwise to tighten in place. Twist counterclockwise to loosen or adjust the ball. T-Bolt Dimensions: .48" x .95"